Adding part weight to drawing
Adding part weight to drawing
(OP)
Hello everyone.
I am currently working on NX 7.5 and have a question on adding part weight to a drawing. I have no NX experience, but I am well versed in SolidWorks and SolidEdge. This being said, in either of these programs I can apply a material to the part and the weight will show up on the drawing via a custom property. Being a newbie, is there an easy way to do this in NX? Thanks!
I am currently working on NX 7.5 and have a question on adding part weight to a drawing. I have no NX experience, but I am well versed in SolidWorks and SolidEdge. This being said, in either of these programs I can apply a material to the part and the weight will show up on the drawing via a custom property. Being a newbie, is there an easy way to do this in NX? Thanks!





RE: Adding part weight to drawing
thread561-263382: mass attribute
thread561-299440: How to list mass in different unit in the Partslist ?
www.nxjournaling.com
RE: Adding part weight to drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Adding part weight to drawing
In our drawings we put the weight in the title block.
Please resolve this issue in some NX 8 MR.
Thank you...
Using NX 8 and TC8.3
RE: Adding part weight to drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Adding part weight to drawing
I'm asking of assembly, not of parts.
Parts have mass attribute, but assembly no.
If is possible, please attach a simple assembly to understand the procedure.
Thank you...
Using NX 8 and TC8.3
RE: Adding part weight to drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Adding part weight to drawing
can I open an ER for support an attribute-based solutions for the mass properties of an Assembly or you think it's very difficult to implement ?
Thank you...
Using NX 8 and TC8.3
RE: Adding part weight to drawing
RE: Adding part weight to drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.