Set DB_PART_NO, DB_PART_REV parametrically
Set DB_PART_NO, DB_PART_REV parametrically
(OP)
Is there a way to have the following Part Attributes set automatically (with no user intervention):
DB_PART_NO
DB_PART_REV
For example, if using military revisioning, part numbers might look like this:
123456.2.5
In this example, the Part Attributes' values would be:
DB_PART_NO = 123456
DB_PART_REV = 2.5
Is there a way, perhaps using new Attributes functionality in NX8, to have these values set with no manual intervention? This would be super useful to avoid mistakes, say, upon new part creation and on Save-As for new revisions.
Thanks in advance.
DB_PART_NO
DB_PART_REV
For example, if using military revisioning, part numbers might look like this:
123456.2.5
In this example, the Part Attributes' values would be:
DB_PART_NO = 123456
DB_PART_REV = 2.5
Is there a way, perhaps using new Attributes functionality in NX8, to have these values set with no manual intervention? This would be super useful to avoid mistakes, say, upon new part creation and on Save-As for new revisions.
Thanks in advance.





RE: Set DB_PART_NO, DB_PART_REV parametrically
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Set DB_PART_NO, DB_PART_REV parametrically
RE: Set DB_PART_NO, DB_PART_REV parametrically
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Set DB_PART_NO, DB_PART_REV parametrically
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli