circle look like rectangle
circle look like rectangle
(OP)
Hello everyone,
I`ve got a problem with view in model. I receive an assembly in which was made a circle, but on model it look like rectangle. When I click on "Information" and next "Object" and I mark this "circle" the information which I receive is "ellipse".
I supposed that constructor apply some simplification... Could someone help what should I do, to see a circle, not rectangle
Best regards
I`ve got a problem with view in model. I receive an assembly in which was made a circle, but on model it look like rectangle. When I click on "Information" and next "Object" and I mark this "circle" the information which I receive is "ellipse".
I supposed that constructor apply some simplification... Could someone help what should I do, to see a circle, not rectangle
Best regards





RE: circle look like rectangle
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit
RE: circle look like rectangle
RE: circle look like rectangle
Best regards
Simon NX7.5.4.4 MP5 - TC 8 www.jcb.com
RE: circle look like rectangle
NX 7.5
Teamcenter 8
RE: circle look like rectangle
RE: circle look like rectangle
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3
RE: circle look like rectangle
www.nxjournaling.com
RE: circle look like rectangle
RE: circle look like rectangle