Face highlighting in "See-Thru" mode
Face highlighting in "See-Thru" mode
(OP)
Is there a way to turn off the mouse-over face highlighting when in see-thru mode? I like this behavior 99% of the time but in see-thru mode I see a hidden feature that I want to select and when I move the mouse towards it to select it the face in front suddenly highlights and hides the thing I was going for. Its like the software is constantly teasing me by dangling the thing I want just out of reach and then snatching it away and hiding it behind its back when I try to grab it.
NX 7.5.4, NX 8.0.1.5
Tecnomatix Quality 8.0.1.3
PC-DMIS 2011 MR1





RE: Face highlighting in "See-Thru" mode
Preferences -> Selection...
...and toggle OFF the 'Highlight Selection on Rollover'.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.