tool and target body do not form complete intersection
tool and target body do not form complete intersection
(OP)
I have a solid body that I'm trying to crate a curvature continuous blend on. For various reasons soft blend won't work. I've created a sheet body using through curve mesh and various curve operations and everything shows up within tolerance but when I try to use the sheet to trim off the blend I get the above message.
is there something I'm missing?
using 7.5 no shape studio license
is there something I'm missing?
using 7.5 no shape studio license





RE: tool and target body do not form complete intersection
RE: tool and target body do not form complete intersection
The patch feature will use the modeling distance tolerance to fix an eventual incomplete intersection and thereby succeed.
If the error message shows up and there definitely is a full intersection, it is a case for GTAC.
RE: tool and target body do not form complete intersection
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: tool and target body do not form complete intersection
(after wasting 2 days trying to do it other ways)
RE: tool and target body do not form complete intersection
Over time we've tried to us this 'tolerant' technology wherever it's practical. However, for things like Sewing surfaces and Patching bodies, Tolerant Modeling has always been part of these tools. We've done some work with Trimming and Booleans, but it's a bit trickier there, but things have gotten better.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.