R20 CATProduct error
R20 CATProduct error
(OP)
My team has been working on a CATProduct for the last two months without issue. Last week, we started seeing some strange behavior when opening the top level product. Somehow, CATIA was building a the top level product correctly, but adding in duplicate data to detail CATParts. Sometimes this duplicate data would correspond to a std. part and sometimes it would correspond to a part we were designing, but it was always added to a CATPart.Not a CATProduct. Take a look at the picture below. I am only showing the std. parts added under the std. part shown, but there are other detail non-std. parts which are also instantiated below. Has anyone run into anything like this? I didn't think you could add a CATPart to a CATPart. I am thinking some of the data has become corrupt. Any thoughts would be greatly appreciated.





RE: R20 CATProduct error
RE: R20 CATProduct error
RE: R20 CATProduct error
RE: R20 CATProduct error
If that does not work, make a backup of the files then try CATDUA under the Utility menu.
Win XP64
R20/21, 3DVIA Composer 2012, ST R20
Dell T7400 16GB Ram
Quadro FX 4800 - 1.5GB