How do you Scale a Symbol within a Tabular Note in NX drafting
How do you Scale a Symbol within a Tabular Note in NX drafting
(OP)
The attached PowerPoint explains the situation better but here goes...
I want to add a symbol to a cell within a "Tabular Note" in NX 7 drafting. I can add the symbol with an attribute call-out but I cannot scale the symbol. I know there is a scale symbol setting but it seems to have no effect. This same idea applied to a "Note" scales perfectly fine.
The attribute that I want to add is:
<W@$SH_SHEET_PROJECTION_ANGLE>
Does anyone know how to scale the symbol in a "tabular note"?
Thanks, Don
I want to add a symbol to a cell within a "Tabular Note" in NX 7 drafting. I can add the symbol with an attribute call-out but I cannot scale the symbol. I know there is a scale symbol setting but it seems to have no effect. This same idea applied to a "Note" scales perfectly fine.
The attribute that I want to add is:
<W@$SH_SHEET_PROJECTION_ANGLE>
Does anyone know how to scale the symbol in a "tabular note"?
Thanks, Don





RE: How do you Scale a Symbol within a Tabular Note in NX drafting
www.nxjournaling.com
RE: How do you Scale a Symbol within a Tabular Note in NX drafting
RE: How do you Scale a Symbol within a Tabular Note in NX drafting
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: How do you Scale a Symbol within a Tabular Note in NX drafting