BEAD - NX7.5
BEAD - NX7.5
(OP)
Hi,
I've found an UG file (attached to this message), that has a Bead feature.
My intention is to recreate this file using Sheet Metal.
I had known that Bead is a tool integrated in Sheet Metal only,
but it looks like the Bead in the attached file belongs to Modeling, not to Sheet Metal.
The NX version I use (7.5) doesn't have this feature.
I am confused.......should I understand that the file has been created in another UG version?
I do not remember to use this feature during my last 4 years experience with UG!
Thanks!
I've found an UG file (attached to this message), that has a Bead feature.
My intention is to recreate this file using Sheet Metal.
I had known that Bead is a tool integrated in Sheet Metal only,
but it looks like the Bead in the attached file belongs to Modeling, not to Sheet Metal.
The NX version I use (7.5) doesn't have this feature.
I am confused.......should I understand that the file has been created in another UG version?
I do not remember to use this feature during my last 4 years experience with UG!
Thanks!





RE: BEAD - NX7.5
RE: BEAD - NX7.5
Best regards
Simon NX7.5.4.4 MP5 - TC 8 www.jcb.com
RE: BEAD - NX7.5
I'd known that creating a bead in Sheet Metal requires a planar face.
I was wondering if someone can give me information about the bead the file I attached has! It is a different sort of bead, not created in Sheet Metal!....
RE: BEAD - NX7.5
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: BEAD - NX7.5
I got it!
RE: BEAD - NX7.5
Best regards
Simon NX7.5.4.4 MP5 - TC 8 www.jcb.com