NX8 Edge fillet
NX8 Edge fillet
(OP)
Hi, I am just moving up to nx8 from 7.5 and for some reason when I do edge fillets, It goes through updating through the hole model and reports warnings from previous features. Is there something new in nx8 causing this. Isn't this time stamped?
Thanks, Brian
Thanks, Brian





RE: NX8 Edge fillet
Could you provide more details as to exactly what you're doing when this happens? Can you describe the steps being take as well as some idea of what the model looks like, maybe even a short video showing this phenomenon taking place? Of course and actual model may be useful as well.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.