NX7.5 Datum target Feature Drafting
NX7.5 Datum target Feature Drafting
(OP)
When Putting in a datum target in 2D drafting in NX the text is a mess inside of this target feature.
Is there settings so I can get consistent Datum target callouts?
In I-Deas it was all automatic and worked really nice.
Please see pic the one on the right was done in I-Deas
Thanks
Is there settings so I can get consistent Datum target callouts?
In I-Deas it was all automatic and worked really nice.
Please see pic the one on the right was done in I-Deas
Thanks





RE: NX7.5 Datum target Feature Drafting
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.