NX 6.0 and saving an assembly
NX 6.0 and saving an assembly
(OP)
Hi,
I have a large assembly with only some parts by me, ie. only I have write access in Teamcenter.
While having the whole assembly active (like Work Part) and I try to save, saving will begin but will apparently fail because I have write access to only my own parts.
-> Despite error messages stating the overall save failed, does NX still save my parts and leave other parts untouched?
I have a large assembly with only some parts by me, ie. only I have write access in Teamcenter.
While having the whole assembly active (like Work Part) and I try to save, saving will begin but will apparently fail because I have write access to only my own parts.
-> Despite error messages stating the overall save failed, does NX still save my parts and leave other parts untouched?





RE: NX 6.0 and saving an assembly
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit