Intersect
Intersect
(OP)
NX 6.0.0.24
I intersected an extruded body with an existing solid body, and the resulting body appears to have short intermittent faces and edges hanging of the part in the direction of the extrusion until I shade the part.
Examine geomtry shows no problems in these aress.
Anybody?
Thanks RM
I intersected an extruded body with an existing solid body, and the resulting body appears to have short intermittent faces and edges hanging of the part in the direction of the extrusion until I shade the part.
Examine geomtry shows no problems in these aress.
Anybody?
Thanks RM





RE: Intersect
View -> Operation -> Regenerate Work...
...and if that doesn't do it, try...
View -> Camera -> Edit...
...and near the bottom of the dialog, in the section labeled 'Clipping', select the 'Fit Planes to Extents' button.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.