open component as
open component as
(OP)
So why did Seimens decide to remove open component as from nx 7.5?
Is there a way to do this in a different operation that I am not finding?
This was a very useful tool for substituting components. This can still be done but requires much more work and time to do. Now there are times I actually have to close the entire assembly to substitute.
This seems like a common thing in the upgrade form NX 5 to NX 7.5. a lot more time to do the same thing.
Is there a way to do this in a different operation that I am not finding?
This was a very useful tool for substituting components. This can still be done but requires much more work and time to do. Now there are times I actually have to close the entire assembly to substitute.
This seems like a common thing in the upgrade form NX 5 to NX 7.5. a lot more time to do the same thing.





RE: open component as
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.