Check-mate tool
Check-mate tool
(OP)
Hi,
I'm looking for a checker that verify the presence of error in assembly constraints.
Someone has built this test ?
Check-mate tool need some particular license type ?
I'm looking for a checker that verify the presence of error in assembly constraints.
Someone has built this test ?
Check-mate tool need some particular license type ?
Thank you...
Using NX 8 and TC8.3





RE: Check-mate tool
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Check-mate tool
there is no OOTB Check for asm constraint problems in NX8-
or am I wrong?
RE: Check-mate tool
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.