Problem opening NX8 part files in NX7.5
Problem opening NX8 part files in NX7.5
(OP)
I have access to NX8.0 but on school campus the computers are installed with NX7.5. When I try to open a file i have made in NX8 at school i get an error saying the part file was made on a new version of the program. I was wondering if there is anyway around this.





RE: Problem opening NX8 part files in NX7.5
That being said, since it appears that you're a student I suspect that this thread will not survive the day.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Problem opening NX8 part files in NX7.5
Technically, the glass is always full.
RE: Problem opening NX8 part files in NX7.5