How to turn on Interpart Link Browser in NX7.5
How to turn on Interpart Link Browser in NX7.5
(OP)
Hello,
Can someone tell me how to switch on the interpart link browser in NX7.5? I don not see it in the drop down under Assemblies, Wave.
Many Thanks
Andy Gaskin
Can someone tell me how to switch on the interpart link browser in NX7.5? I don not see it in the drop down under Assemblies, Wave.
Many Thanks
Andy Gaskin





RE: How to turn on Interpart Link Browser in NX7.5
Assemblies -> Wave -> Interpart Link Broswer...
...but only if you're using a Role which includes 'Full Menus'.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: How to turn on Interpart Link Browser in NX7.5
Thanks for that info. I have selected the "advanced with full menus" role but still do not see Interpart Link Browser. Do I need a special licence? Or do I need to tick something on in customer defaults?
Regards
Andy Gaskin (Plastic Omnium Auto Exterior UK)
RE: How to turn on Interpart Link Browser in NX7.5
We have no Wave Control Licence available at the moment.
We have just had a new install on Windows 7. I was expecting everything to work as normal but alas settings need to be remade.
Thanks anyway.
Andy gaskin (Plastic Omnium Auto Exterioer UK)