Changing Fixed Datum Planes to just Datum Planes in NX 7.5
Changing Fixed Datum Planes to just Datum Planes in NX 7.5
(OP)
Hey all
Quick question. In the class I'm taking that uses NX we aren't suppose to use "Fixed Datum Plane" and it's showing up in my history that there were multiple fixed datum planes created. Is there a way to change these from not being fixed to regular without screwing up the model? If so, how would I go about doing that?
Thanks
Quick question. In the class I'm taking that uses NX we aren't suppose to use "Fixed Datum Plane" and it's showing up in my history that there were multiple fixed datum planes created. Is there a way to change these from not being fixed to regular without screwing up the model? If so, how would I go about doing that?
Thanks





RE: Changing Fixed Datum Planes to just Datum Planes in NX 7.5
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Changing Fixed Datum Planes to just Datum Planes in NX 7.5