Variable Net Width???
Variable Net Width???
(OP)
Hi,
I use Altium DXP 2004 and Altium 10.
Now, may anyone answer me is there a way to declare different line width for the same net on PCB? I could not make it. Whenever I declare net width on schematics, it refer to the whole net always, so i get i.e., GND connected or with fat line everywhere or with tin line everywhere. Is there a way to specify i.e. if i want some small components to be connected with tin line, and some energetic components with fat line?
Thanks a lot!!!





RE: Variable Net Width???
This forum doesn't get much traffic, so I would suggest the Altium forums...
Dan - Owner

http://www.Hi-TecDesigns.com