Fillet weld on rod
Fillet weld on rod
(OP)
Question...
The 1/2in dia. rod is sitting on a 1/8in plate half-way in. Please see pic attached
To design adequacy of the fillet weld of the rod as shown below, is it ok to assume planar dimension of weld groups?
The 1/2in dia. rod is sitting on a 1/8in plate half-way in. Please see pic attached
To design adequacy of the fillet weld of the rod as shown below, is it ok to assume planar dimension of weld groups?






RE: Fillet weld on rod
I'm sorry, I don't recognize what you mean by "planar dimension of weld groups" ....