Pressure Vessel Nozzle FEA - Constraint Help
Pressure Vessel Nozzle FEA - Constraint Help
(OP)
I am looking at analysing a nozzle on a pressure vessel in solidworks simulaltion (Cosmos). My attempts so far have resulted in unrealstic stresses / failed runs - my guess is this is down to being over constrained?? Can anyone provide some guidance as to how the model should be constrained.
Model is attached (SW 2009 version)...........
Model is attached (SW 2009 version)...........






RE: Pressure Vessel Nozzle FEA - Constraint Help
TOP
CSWP, BSSE
www.engtran.com www.niswug.org
www.linkedin.com/in/engineeringtransport
Phenom IIx6 1100T = 8GB = FX1400 = XP64SP2 = SW2009SP3
"Node news is good news."
RE: Pressure Vessel Nozzle FEA - Constraint Help