[NX 7] Intersection point
[NX 7] Intersection point
(OP)
Hi,
I've a multi-body part, where I need to rotate the connector from the intersection point born from connector axis and the plane.
I'm not able to create this intersection point.
I've a multi-body part, where I need to rotate the connector from the intersection point born from connector axis and the plane.
I'm not able to create this intersection point.
Thank you...
Using NX 8 and TC8.3





RE: [NX 7] Intersection point
So place a datum plane on each face that you want an interestion of.
RE: [NX 7] Intersection point
RE: [NX 7] Intersection point
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: [NX 7] Intersection point
I add an ER to GTAC.
Thank you...
Using NX 8 and TC8.3