NX7.5-Sheet Metal Shape
NX7.5-Sheet Metal Shape
(OP)
Hi,
I assume that Sheet Metal tool would accept only plane surfaces.
But I am not sure. Attached to this mesagge is a bracket.
I was wondering if it can be created(and unfolded) using Sheet Metal.
Thanks
I assume that Sheet Metal tool would accept only plane surfaces.
But I am not sure. Attached to this mesagge is a bracket.
I was wondering if it can be created(and unfolded) using Sheet Metal.
Thanks





RE: NX7.5-Sheet Metal Shape
"Sheet Metal" can only do press brake parts.
RE: NX7.5-Sheet Metal Shape
RE: NX7.5-Sheet Metal Shape