Very Large UNC taps
Very Large UNC taps
(OP)
I'm looking for a source for a very large tap.
3.625-16 UNC 3B to be exact.
Any style will do. Any Ideas?
Thanks,
J
3.625-16 UNC 3B to be exact.
Any style will do. Any Ideas?
Thanks,
J
NX 6.0.5.3





RE: Very Large UNC taps
RE: Very Large UNC taps
You could give this place a try: http://www.tapsndies.com
It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
RE: Very Large UNC taps
It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
RE: Very Large UNC taps
RE: Very Large UNC taps
The tap would be an expensive, single-purpose tool.
Software For Metalworking
http://closetolerancesoftware.com
RE: Very Large UNC taps
See attachment for thread info on your size.
This size is big enough to bore with insert. No need to tap.
3-5/8-16 3B is a Fine Pitch
- CJ
RE: Very Large UNC taps
http://www.powerhousetool.com/taps.htm
RE: Very Large UNC taps
h
RE: Very Large UNC taps
Thanks! That is pretty much exactly what I was looking for!
J
NX 6.0.5.3