Information window
Information window
(OP)
Is there a way to auto close the information window? Like the info window when updating a part family or when you did a rename in TC the info window always pop up.
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit





RE: Information window
RE: Information window
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Information window
Anyhow thanks for the clarification.
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit