NX6 - Drafting - Adding database attributes to a table
NX6 - Drafting - Adding database attributes to a table
(OP)
I can't seem to get any of the assigned database attributes to show up in a table in drafting mode. I type any one of the following commands and I get nothing in the cell and no error:
<W$=@$MATERIAL>
<W$=@MATERIAL>
<W=@MATERIAL>
The only "error" I get is after I type in any one of the aforementioned commands, NX adds a question mark between the @ and the Material string.
Yes, I have gone to File > Properties > Attributes Tab and given the Material Title a value of Titanium.
What am I missing?
<W$=@$MATERIAL>
<W$=@MATERIAL>
<W=@MATERIAL>
The only "error" I get is after I type in any one of the aforementioned commands, NX adds a question mark between the @ and the Material string.
Yes, I have gone to File > Properties > Attributes Tab and given the Material Title a value of Titanium.
What am I missing?





RE: NX6 - Drafting - Adding database attributes to a table
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.