NX CAM Courses/ Training and Post Processor Companies
NX CAM Courses/ Training and Post Processor Companies
(OP)
Hi,
I have taken the Siemens course "Introduction to NX for Experienced Users" this covers only the Cad side of the software.
What courses should I look into for the CAM side of NX 8.0 or 7.5?
I am currently programming with Mastercam X6 and we would like to switch to NX.
Also is there a list of companies that supplies post processors?
Thanks in advance!
Hockeyguy
I have taken the Siemens course "Introduction to NX for Experienced Users" this covers only the Cad side of the software.
What courses should I look into for the CAM side of NX 8.0 or 7.5?
I am currently programming with Mastercam X6 and we would like to switch to NX.
Also is there a list of companies that supplies post processors?
Thanks in advance!
Hockeyguy





RE: NX CAM Courses/ Training and Post Processor Companies
You can also get on-line training at www.myigetit.com
As far as Post processors you can get them through Siemens and there are some other companies that allegedly supply them. If I needed a post and could not develop it myself I would probably have Siemens create it for us.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3
RE: NX CAM Courses/ Training and Post Processor Companies
In NX, there are some CAM tutorials OOTB to get you started. Go to Help --> Manufacturing Tutorials.
After that, we offer the 3-5 day classes, depending on what kinds of parts you program.
If you are going to write or maintain your own posts, take the Post Building Techniques class - no question about that.
Mark Rief
Product Manager
Siemens PLM