Expressions
Expressions
(OP)
I know I can create If/Else formulas within expressions, and have been able to make them funtion. My question is, can I do If/Then statements? I want to drive the location of an endpoint in a sketch from any one of multiple points. For example:
If A=1 Then B=X
If A=2 Then B=Y
If A=3 Then B=Z
And so on. How can I make this happen? This is just one feature of a model and I don't want to get into part families.
Thanks
If A=1 Then B=X
If A=2 Then B=Y
If A=3 Then B=Z
And so on. How can I make this happen? This is just one feature of a model and I don't want to get into part families.
Thanks





RE: Expressions
http://www.eng-tips.com/viewthread.cfm?qid=196582
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit
RE: Expressions
RE: Expressions