NX8 Assembly doesn't load complete
NX8 Assembly doesn't load complete
(OP)
We are using NX8. We made an assembly with some reusable parts from a NX6/NX8 library. When we open it again some of the reusable parts are missing. What are we doing wrong?





RE: NX8 Assembly doesn't load complete
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX8 Assembly doesn't load complete
Will "refile" give problems to earlier assemblies made bij NX6?
We have changed our computer with NX6 to a new one with NX8.
RE: NX8 Assembly doesn't load complete
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.