NX7.5 Extrude Dimension display.
NX7.5 Extrude Dimension display.
(OP)
I am modeling a die cast housing. I am trying to keep wall thickness constant with reusing the same wireframe ect. This is working ok but I went into an extrude and I see the following.
-2.65 // Used By ...
what is going on? Did I do something wrong?
In My model I have an Expression set up with a value set to wall thickness.
-2.65 // Used By ...
what is going on? Did I do something wrong?
In My model I have an Expression set up with a value set to wall thickness.





RE: NX7.5 Extrude Dimension display.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7.5 Extrude Dimension display.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.