VIEW BOUNDRY BREAKE SHAPE- NX 7.5
VIEW BOUNDRY BREAKE SHAPE- NX 7.5
(OP)
Hi,
How could I create a view with boundary shape like the one created in the attachemnt?(It simulate a break symbol)
Thanks
How could I create a view with boundary shape like the one created in the attachemnt?(It simulate a break symbol)
Thanks





RE: VIEW BOUNDRY BREAKE SHAPE- NX 7.5
RE: VIEW BOUNDRY BREAKE SHAPE- NX 7.5
Insert -> View -> Broken...
...but instead of defining two end sections while removing the center, instead just define a single center section removing the two ends, as seen below:
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: VIEW BOUNDRY BREAKE SHAPE- NX 7.5
RE: VIEW BOUNDRY BREAKE SHAPE- NX 7.5
I can't follow your option, but I'd love to learn it.
Could you send me a sample and step-by-step direction, please?...
Thanks
RE: VIEW BOUNDRY BREAKE SHAPE- NX 7.5
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: VIEW BOUNDRY BREAKE SHAPE- NX 7.5