Automatically copy to clipboard
Automatically copy to clipboard
(OP)
Hello,
I have problem with selection in NX. In Preferences - Selection is selected option "Inside/Crossing". After selection entities to window (with mouse), system show message "Objetcs have been copied onto the clipboard" and entities is deselected. What is the problem? Problem is in NX4 and NX8.
Thanks.
NX 4.0.4.2 MP10
NX 8.0.0.25 MP1
I have problem with selection in NX. In Preferences - Selection is selected option "Inside/Crossing". After selection entities to window (with mouse), system show message "Objetcs have been copied onto the clipboard" and entities is deselected. What is the problem? Problem is in NX4 and NX8.
Thanks.
NX 4.0.4.2 MP10
NX 8.0.0.25 MP1
NX 4.4.0.2 MP10





RE: Automatically copy to clipboard
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Automatically copy to clipboard
NX 4.4.0.2 MP10
RE: Automatically copy to clipboard
NX 4.4.0.2 MP10
RE: Automatically copy to clipboard
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Automatically copy to clipboard
NX 4.4.0.2 MP10