Part Refuses to Move
Part Refuses to Move
(OP)
This may be a silly question but it's been causing me all sorts of trouble today. I opened up an assembly that includes another assembly part (solar panel). I've gotten rid of all constraints, but I still can't move the solar panel. When I try to, the entire part becomes red. Any way to fix this?





RE: Part Refuses to Move
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Part Refuses to Move
Perhaps this is due to "Move Component, Settings, Collision Detection, Collision Action" set to "Highlight Collision" or "Stop Before Collision"? (as opposed to "None")
HTH,
Joe
RE: Part Refuses to Move