out of squareness when projected tol zone not used
out of squareness when projected tol zone not used
(OP)
Hi All,
I would like to know how the following formula is derived.
H = F + T1 +T2 (1 + 2P/D)
Is any one good in mathematics, who can help me in understanding how these formula is derived?
Thanks for your time
Madhusudhan
I would like to know how the following formula is derived.
H = F + T1 +T2 (1 + 2P/D)
Is any one good in mathematics, who can help me in understanding how these formula is derived?
Thanks for your time
Madhusudhan





RE: out of squareness when projected tol zone not used
RE: out of squareness when projected tol zone not used
I said it was hard to present how the formula was derived, but I decided to try anyway.
Look at attached pdf. First page is showing my thought process for deriving 'classic' fixed fastener positional callout formula. I presented it just because very similar approach was used for finding the formula you were asking for.
I am sure there are also different ways to get to the same result.
h
RE: out of squareness when projected tol zone not used
Nice work, a star for your effort.
RE: out of squareness when projected tol zone not used
Really a wonderfull presenation. Thanks for your time :)
RE: out of squareness when projected tol zone not used
What a beautiful start for a day!
Logged in just to give credit when credit is due.
In today's world of memorizing without understanding my hat is off to you, sir!
RE: out of squareness when projected tol zone not used
SeasonLee