F8 BUTTON
F8 BUTTON
(OP)
IN UNIGRAPHICS THE F8 BUTTON WILL CHANGE YOUR VIEW TO THE CLOSEST ABSOLUTE VIEW. THE BUTTON CAN NO LONGER BE USED ON THE SPACEBALL 5000. ANY SUGESTIONS?
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: F8 BUTTON
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: F8 BUTTON
3DXNX>BUTTON MAP EDITOR
HELP>ONLINE SUPPORT>SNAP VIEW
I HAVE NO IDEA WHY BUT WAS UNABLE TO PROGRAM THE F8 BUTTON?
RE: F8 BUTTON
Suggestion: try it!
NX 7.5
Teamcenter 8
RE: F8 BUTTON
SUGESTIONS: GET USED TO IT
RE: F8 BUTTON
F8 is also handy because it will orient your view to the selected planar entity (face, datum plane, etc) even if it is not parallel to an ortho view.
Which reminds me...
John, did you find anything regarding thread561-247593: NX6 and F8?
RE: F8 BUTTON
RE: F8 BUTTON
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: F8 BUTTON
I just checked out NX 7.5 and if you use the default 'Load Lightweight Representations' option than you will also need to toggled ON the 'Load Smart Lightweight Data' option found at...
Customer Defaults -> Assemblies -> Site Standards -> Lightweight Representations
However, if you're not opening your assembly using Lightweight Representations then the F8 function will now work whether Partial Loading is ON or not, just like it always did prior to NX 5.0.
As for NX 6.0.5.3, it's still NOT behaving as it did prior to NX 5.0, so somewhere in either NX 7.0 or NX 7.5, someone addressed this issue.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: F8 BUTTON
I'm on 7.5 now and it seemed to be working, but have not done thorough testing. Glad to hear it was fixed.
RE: F8 BUTTON
Apparently it's not his problem but ours.
FILB,
It is common courtesy, especially when asking others for assistance, not to shout at them. They will be less likely to render aid to you in the future when shown such disrespect. That I can get used to also.
"Good to know you got shoes to wear when you find the floor." - Robert Hunter
RE: F8 BUTTON