NX 7.5 - New to assigning drafting attributes
NX 7.5 - New to assigning drafting attributes
(OP)
My previous employer had all of this set up, therefore i was spoiled.
I just need the basics on how to create parametric text within my title block in my drawing template, for example, the name of the part file will always show up as the actual file name. Or, the customers name, date, etc...
Thanks in advance,
Rick
I just need the basics on how to create parametric text within my title block in my drawing template, for example, the name of the part file will always show up as the actual file name. Or, the customers name, date, etc...
Thanks in advance,
Rick





RE: NX 7.5 - New to assigning drafting attributes
http://www.eng-tips.com/viewthread.cfm?qid=292619
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.