Unigraphics NX 7.5.2.5 Pre-Selection Hi-Lite
Unigraphics NX 7.5.2.5 Pre-Selection Hi-Lite
(OP)
I am looking for the toggle for the pre-selection hi-lite in NX,
If I am not mistaken, when you put your curser over a component in an assembly it will hi-lite for selection.
Where is the toggle?
If I am not mistaken, when you put your curser over a component in an assembly it will hi-lite for selection.
Where is the toggle?
tmmoreno





RE: Unigraphics NX 7.5.2.5 Pre-Selection Hi-Lite
Preferences -> Selection...
...and make sure that the first option, 'Highlight Selection on Rollover' is toggled ON in the 'Highlight' section of the dialog.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.