HD3D Tools
HD3D Tools
(OP)
Does any body know how to turn off the HD3D Tools permanently. It's just annoying at times, and I don't really use it.
Thanks for the info if there is any.
CID (NX8)
Thanks for the info if there is any.
CID (NX8)





RE: HD3D Tools
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: HD3D Tools
RE: HD3D Tools
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: HD3D Tools
I use the pocket command from my moldwizard toolbar. This was never a issue in 7.5, it seems NX8 has a few bugs that need to be worked out, I have contacted Gtac and Doug Gudorf, for some other major issues that I have experienced, namely the error dialog box not always coming up when it needs to and when that doesn't come up nothing will update, so then you have to shutdown and restart your NX session, I know some people say memory leakage but it was never a problem in any other NX series, it's the software.