Invalid storage area identifier
Invalid storage area identifier
(OP)
Dear Colleagues!
I'm usind UGS NX 6.0, and i badly need some help for simulatian.
I prepared the kinematic model of my machine, defined it's parameters, also prepared the postprocessor
according to the NX 6 Documentation.
In the Manufacturing module When i'm ritrieving my machine from the Libary, i permanently get the message of:
"Invalid storage area identifier".
I see my Part displayed correctly beneath the message window, but when hitting OK, my machine dissappears
from the screen, and i'm redirected to the window of the Libary.
How to get through this point?
Thanks in advance!
I'm usind UGS NX 6.0, and i badly need some help for simulatian.
I prepared the kinematic model of my machine, defined it's parameters, also prepared the postprocessor
according to the NX 6 Documentation.
In the Manufacturing module When i'm ritrieving my machine from the Libary, i permanently get the message of:
"Invalid storage area identifier".
I see my Part displayed correctly beneath the message window, but when hitting OK, my machine dissappears
from the screen, and i'm redirected to the window of the Libary.
How to get through this point?
Thanks in advance!





RE: Invalid storage area identifier
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli