How to cheng "snaping" valiue in modyfikation
How to cheng "snaping" valiue in modyfikation
(OP)
When I am editing surface of solid (using Synchronouse mode) then I can move that surface with resolution: 0.01mm, (for example 1.86...1.85...1.84....
I want to have resolution of 1mm that's mean: 1mm ... 2.... 3... and so on
How can I set it up ?
h ttp://www. angelfire. com/virtua lprototypi ng/Solid_E dge_Questi on_about_g rid_dimens ioning.pdf
I want to have resolution of 1mm that's mean: 1mm ... 2.... 3... and so on
How can I set it up ?
h




