UHX vs Appendix 41
UHX vs Appendix 41
(OP)
Does anyone have any information regarding the creation of mandatory Appendix 41?
a) Why was it not incorporated into UHX which is a very similar application?
b) I have been told that using App. 41 will allow the use of standard ANSI flanges with their full B16.5 temperature/pressure ratings. Does this make sense especially since the elements do not contribute to the strength of the support plate?
a) Why was it not incorporated into UHX which is a very similar application?
b) I have been told that using App. 41 will allow the use of standard ANSI flanges with their full B16.5 temperature/pressure ratings. Does this make sense especially since the elements do not contribute to the strength of the support plate?




