missing conical surface icon
missing conical surface icon
(OP)
well, I'm facing this issue with Creo/Proe5
the help file says that there is this command:
"create conical surface"
http: //www.kxca d.net/proe /restyle/t o_create_a _conical_s urface.htm
whilst, AS USUAL, I can't find it.
Obviously (note the sarcastic tone) this command was already in ProE w3, according to its help file, but I couldn't find it at the time, too.
So after three hours of frustration and nerve crisis I feel the right to think that doing interfaces and help files so badly is just criminal, an utter disregard towards users' health.
Is there anyone willing to point out the right solution?
I'm considering to hire a private detective to find the missing button.
the help file says that there is this command:
"create conical surface"
http:
whilst, AS USUAL, I can't find it.
Obviously (note the sarcastic tone) this command was already in ProE w3, according to its help file, but I couldn't find it at the time, too.
So after three hours of frustration and nerve crisis I feel the right to think that doing interfaces and help files so badly is just criminal, an utter disregard towards users' health.
Is there anyone willing to point out the right solution?
I'm considering to hire a private detective to find the missing button.





RE: missing conical surface icon
The good man who wrote the help file did not mention that it is nested into the following path:
Menu: Insert/Restyle
a new menu item named "Restyle" itself appears in the menu bar, and the Restyle toolbar appears on the right side
From the menu bar:
Restyle/Analytical_Sufaces/Cone
From the toolbar:
the icon is amongst those on the third line
Wow! I'm ready for the next Treasury Hunt!