Post builder - millimeters vs. inches
Post builder - millimeters vs. inches
(OP)
Hello,
Is it possible to change the post output unit in a default pp?
If I open lathe_tool_tip.pui, I can't see where to do it.
Thanks
Is it possible to change the post output unit in a default pp?
If I open lathe_tool_tip.pui, I can't see where to do it.
Thanks





RE: Post builder - millimeters vs. inches
RE: Post builder - millimeters vs. inches
In NX8, we added the ability for a dual units post. This is done with a sub-post that contains only the settings that are different between the units.
Mark Rief
Product Manager
Siemens PLM