In NX7.5 specify segments for approximation is missing?
In NX7.5 specify segments for approximation is missing?
(OP)
NX6 can smooth a spline approximation for defining a number of segments.
In NX7.5 is no longer possible?
I thank those who can give me suggestions.
Ciao.
In NX7.5 is no longer possible?
I thank those who can give me suggestions.
Ciao.





RE: In NX7.5 specify segments for approximation is missing?
Edit -> Curve -> Smooth Spline...
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: In NX7.5 specify segments for approximation is missing?
nx7.5 missing in the approximation for the number of segments
RE: In NX7.5 specify segments for approximation is missing?
RE: In NX7.5 specify segments for approximation is missing?
RE: In NX7.5 specify segments for approximation is missing?
Edit->Curve->Parameters->OK
then
->Smooth
then
->Segment
then
->Approximate
In NX7.5 is no longer possible.
RE: In NX7.5 specify segments for approximation is missing?
This behavior is the same as in NX6.
RE: In NX7.5 specify segments for approximation is missing?
Thanks for the suggestions.
Ciao.