Broken Radius Line
Broken Radius Line
(OP)
Hello people!
I start to work with NX 7.5, and allready have questions. For start, how can I make this broken line on image?
Regards
Cvik
I start to work with NX 7.5, and allready have questions. For start, how can I make this broken line on image?
Regards
Cvik





RE: Broken Radius Line
Note that you need to pre-create the 'center' point, which can be anywhere that's convenient for you.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Broken Radius Line