Missing parts on drawing sheets
Missing parts on drawing sheets
(OP)
On making a drawing of large assembly, a few parts refuse to appear on the drawing sheet. Fully loaded state is on and I did check the show/hide menu, but still some parts appear where others do not. I had this in NX7.5 and now in NX8.0, what am I doing wrong here ?
Thanks for any hints
Thanks for any hints





RE: Missing parts on drawing sheets
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.