need help on a pc board
need help on a pc board
(OP)
Don't know if this is right forum.
But, here goes
Does anybody here have a circuit diagram or can tell me where to get one of a PC board in the receiver control unit of a Casablanca fan with a wall mounted W32 controller.
My problem is that this "world class" fan has inferior electronics and the Mfr are not helpful in helping the consumer troubleshooting their boards. They think it is OK to throw away a pc board at $116 a pop when all it probably has is a blown cap or resistor. I guess this is the American service system .
But, here goes
Does anybody here have a circuit diagram or can tell me where to get one of a PC board in the receiver control unit of a Casablanca fan with a wall mounted W32 controller.
My problem is that this "world class" fan has inferior electronics and the Mfr are not helpful in helping the consumer troubleshooting their boards. They think it is OK to throw away a pc board at $116 a pop when all it probably has is a blown cap or resistor. I guess this is the American service system .





RE: need help on a pc board
Below is a link with upset owners, and a link to a youtube where someone shows you how to repair the circuit board (apparently in some models it's only a resistor that fails).
http://w
http://www.youtube.com/watch?v=1pWn2GM_9lI
RE: need help on a pc board
Thanks for the reply. I had seen both links and they don't help much.
I took the PC receiver board out and found a burnt out TRIAC in my case. Without any circuit diagram I am flying blind. I will replace the TRIAC and see what happens.
My, advice, don't buy a Casablanca fan; they not only can't do the electronics design properly, but have the gall to withhold vital information for an owner to do the repairs, forcing the average owner to make a choice of paying upwards of $200 in parts Plus service or simply discarding the unit and buying a more reliable one at less than the cost of repairs.
I am also truly surprised that a circuit diagram hasn't emerged
on Google, since this problem has been around for at least 7 years.
RE: need help on a pc board
Keith Cress
kcress - http://www.flaminsystems.com
RE: need help on a pc board
Keith Cress
kcress - http://www.flaminsystems.com