NX 8 Datum Plane Message
NX 8 Datum Plane Message
(OP)
I am using NX8 and when using the datum command and if you pick one of the csys planes and go to a point if gives this message, now in NX 7.5 you could go from a plane on your csys to point and there was no message and it stayed parallel to the plane that you picked on the csys, in NX 8 it doesn't. Check the attached picture.





RE: NX 8 Datum Plane Message
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 8 Datum Plane Message
RE: NX 8 Datum Plane Message
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 8 Datum Plane Message
RE: NX 8 Datum Plane Message
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.