How to identify Basic Curves using NXOpen?
How to identify Basic Curves using NXOpen?
(OP)
Hi all,
is there any way to identify Basic Curves using NXOpen? Any help in this regard is greatly appreciated..
Regards,
Koutilya
is there any way to identify Basic Curves using NXOpen? Any help in this regard is greatly appreciated..
Regards,
Koutilya





RE: How to identify Basic Curves using NXOpen?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: How to identify Basic Curves using NXOpen?
Thanks for your quick reply. Basic curves means those lines & arcs which won't list in the feature browser dialog. I am attaching the image for your better understanding.
RE: How to identify Basic Curves using NXOpen?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.