Epoxy Grout
Epoxy Grout
(OP)
I will install threaded anchor bolts (1" diameter F1554 55, post installation) and try to use Sikadur 32, Hi-mod epoxy grout. I am unable to find the following information on the Sika Corporation web site.
1. What size of hole for 1" anchor rod?
2. Does Sikadur 32, Hi-mod have Freeze Thaw issue?
3. Is Sikadur 32 for short term loading or for long term loading (i.e. 30 years)?
Could someone provide some your experience and opinions on above issues? Thank you.
1. What size of hole for 1" anchor rod?
2. Does Sikadur 32, Hi-mod have Freeze Thaw issue?
3. Is Sikadur 32 for short term loading or for long term loading (i.e. 30 years)?
Could someone provide some your experience and opinions on above issues? Thank you.






RE: Epoxy Grout
RE: Epoxy Grout
Also epoxies are no suitable for sustained long term loading as they are susceptable to creep.
RE: Epoxy Grout
I reviewed a lot of Sika information in internet. The old Sika specification stated that it is for grout bolt, rabar, etc. But the current Sika documentations are not stating it is for grouting bolts, rebar. So I concern that this product may have some issues in the past. I did call Sika Repesentative but I am unable to get enough information to make decision. So I come here to have some opinions.
If I am not using Sikaur 32 Hi-Mod, I may use Sikaur 328 cement based grout. I am right now only have some knowlege and experience on Sika grout. Could you please provide me some experience on Sika 328 grout or some other manufacturer products?
Thank you again.
RE: Epoxy Grout
RE: Epoxy Grout
Brad
RE: Epoxy Grout
Sika is not a fastener company, it is a chemical company.
RE: Epoxy Grout
http://www.FerrellEngineering.com
RE: Epoxy Grout