NX6 exploded view arrangements
NX6 exploded view arrangements
(OP)
I have an exploded view in modeling with some parts supressed. I created an arrangement of the supression configuration for the explosion. When I place the explosion in drafting, I select TFR-TRI to get the explosion but then the arrangement selection pull down menu disappears?
So my question is how do apply an arrangement (or part suppression configuration) to an exploded view in drafting?
So my question is how do apply an arrangement (or part suppression configuration) to an exploded view in drafting?





RE: NX6 exploded view arrangements
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 exploded view arrangements
RE: NX6 exploded view arrangements
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.